International Conference
Moreover, in the early stages the most promising application of a 40% solution as an additive in polystyrene mixture in an amount up to 2% by weight of polystyrene, thus achieving a reduction in consumption of liquid glass in 2 times, increase the strength of the mixture in dried state at 8-10. But in this case we find that the positive effect that These mixtures are legkovybivaemymi, upon heating above 300 C, they can easily spill out of the cavities of the casting, sand cores made. Thus, by adjusting in the range of 1-2% of this additive, engineer-founder gets gamut legkovybivaemyh mixtures for various conditions of casting (mass casting a rod, a kind of alloy), the competitive strength of resin. A design for recycling polystyrene foam technology by dissolving the gum in turpentine obtained data show a very wonderful opportunity to compaction. According to the table in one unit (46 cm3) of 40% solution is placed 19.14 volume units (880.5 cm3) of waste polystyrene foam, and with respect to source 30 cm3 of solvent that the volume of waste more time in 29.35. Questions or References 1.
O. Shinskij, V. Doroshenko, A. Striuczenko, J. Ladarieva. Recykling polistyrenu piankowego / / Recykling. (Miesiecznik ogolnopolski. Poznan) – 2008 .- 1 – P.28-29 2.
IV International Conference "Replast 2007. Recycling of plastics. " Moscow. 3. Bedrik BG, Chulov PV, Kalashnikov, SI Solvents and cleaning compounds for machinery: A Handbook. – Moscow: Khimiya, 1989.-176 with. 4. Shinsky O.Y., Terlkovsky .V., Stryuchenko AA, that n. Dekle. U.S. Pat. Ukraine 9003 vd 15.09.2005. Zastosuvannya gum turpentine for yak rozchinnika vdhodv pnopolstirolu. Bull. 9. 5. Shinsky O.Y., Naydek VL Stryuchenko AA, that n. U.S. Pat. Ukraine 77 338. Polstirolne zv'yazuyuche for vigotovlennya livarnih forms that sterzhnv – publ. 15.11.2006, Bull. 11. 6. Shinsky OI Doroshenko, VS, AA Stryuchenko Sand mixture, based on polystyrene for molds and cores with higher crude compressive strength. Casting the 2008 Abstracts. Reports .- K. editors of "casting process", 2008. – S.193 – 194.
Tags: industry, technology